![]() (iii) When surcharge loads from stored material or equipment, operating equipment, or traffic are present, a competent person shall determine the degree to which the actual slope must be reduced below the maximum allowable slope, and shall assure that such reduction is achieved. If that situation occurs, the slope shall be cut back to an actual slope which is at least ½ horizontal to one vertical (½H:1V) less steep than the maximum allowable slope. (ii) The actual slope shall be less steep than the maximum allowable slope, when there are signs of distress. (i) The actual slope shall not be steeper than the maximum allowable slope. ![]() The maximum allowable slope for a soil or rock deposit shall be determined from Table B-1 of this appendix. Soil and rock deposits shall be classified in accordance with appendix A to subpart P of part 1926. Short term exposure means a period of time less than or equal to 24 hours that an excavation is open. Maximum allowable slope means the steepest incline of an excavation face that is acceptable for the most favorable site conditions as protection against cave-ins, and is expressed as the ratio of horizontal distance to vertical rise (H:V). Distress is evidenced by such phenomena as the development of fissures in the face of or adjacent to an open excavation the subsidence of the edge of an excavation the slumping of material from the face or the bulging or heaving of material from the bottom of an excavation the spalling of material from the face of an excavation and ravelling, i.e., small amounts of material such as pebbles or little clumps of material suddenly separating from the face of an excavation and trickling or rolling down into the excavation. ![]() The requirements of this appendix apply when the design of sloping and benching protective systems is to be performed in accordance with the requirements set forth in § 1926.652(b)(2).Īctual slope means the slope to which an excavation face is excavated.ĭistress means that the soil is in a condition where a cave-in is imminent or is likely to occur. This appendix contains specifications for sloping and benching when used as methods of protecting employees working in excavations from cave-ins. Appendix B to Subpart P of Part 1926-Sloping and Benching
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |